- Home
- File service
- Dimsport / Trasdata
File service for Dimsport / Trasdata
File service for Dimsport New Genius and Trasdata
New Genius via OBD, Trasdata via bench and boot – as a slave the file runs through the master panel, as a master you upload it open. It comes back in the format of your tool, typically within minutes.
How it works with Dimsport / Trasdata
Read out
Via OBD with New Genius, via bench or boot with Trasdata. Read the complete file and save it exactly as the tool writes it – no converting.
Upload
Slave files from New Genius or Trasdata you upload directly, master files as open files. Choose vehicle, ECU, read method and services – the cost is shown live next to the form.
Master panel, KENBot, by hand
Slave files are decrypted via the Dimsport master panel. Then KENBot processes them automatically, around the clock, typically within minutes. Whatever the automation does not know, I do by hand on weekdays between 9 am and 6 pm.
Write back
Slave files come back re-encrypted in Dimsport format, ready to write with New Genius or Trasdata; the tool calculates the checksum when writing. Open files come back with the checksum corrected. The original stays saved on the order.
What to keep in mind with Dimsport / Trasdata
Two tools, one principle
New Genius reads via OBD, Trasdata via bench and boot. Both exist as master and as slave. Slave files can only be opened by the assigned master – so your tool has to be assigned to KENBES as master. That is settled at approval.
Trasdata for bench and boot
If the ECU does not deliver a complete read via OBD, Trasdata is the way: bench on the table or boot directly on the ECU. Upload the file as Trasdata saves it, without converting.
What belongs in the note
Hardware changes, existing third-party software, gearbox type for gearbox orders, customer wishes. And the read method if it differs from the usual – boot instead of OBD, for example.
Prices. One token is one Stage 1. Options on top of a stage from 0.25 tokens, credit never expires, not feasible means the token comes back. All prices and packages
Questions about Dimsport / Trasdata
Can I have a New Genius slave file processed?
Yes. You upload the slave file, the portal opens it via the master panel, KENBot or I process it, and it comes back encrypted – ready to write with your New Genius. No master tool needed.
Does Trasdata slave work the same way?
Yes, the same route: upload the slave file, master panel, processing, back in Trasdata format. Bench and boot reads are usually complete and therefore a good basis.
What does a Dimsport file cost?
The same as any other: one token for Stage 1, that is €100 net, €80 per token in the pack of ten. Slave or master makes no difference. Not feasible means the token goes back, revision is included.
File service for other tools
Test your first Dimsport / Trasdata file for free
Register, get approved, use 1 token of starting credit.